Zinc Plated Mild Steel Square bolt (C bolt) complete with 1 full nut and 1 half nut on each leg To Suit 8080 RHS (Rectangular hollow Section) Ideally suited for use with standard rectangular hollow section, but of course will have many uses These 1124 series are for holding just one RHS onto a supporting material not exceeding thickness 2A See 1125 series which are extended leg for thickness of supporting material greater than 2A Please refer to diagram for details (all measurements in mm): RHS : 8080 A = 12 mm B = 82 mm C = 116 mm D = 36 mm Centers = 94 mm Our manufacturing tolerances are + / - 1 mm) We use roll threading so the diameter of the bar is usually less than the thread size. Please ask if unsure