The cutting is more ordered, so that the edges and corners adjust more closely Cut the edges more easily and properly Portable Turning Artifact, you are the Turning Master How to use the Locator Auxiliary Clock Film, Facilitating the Application of the Film Start by drilling the movie in the groove with a knife Move the positioner and the film cut at the same time After glue the film on the surface of the furniture, wipe -The about 10 cm from the edge of the table to stop it. Hold the positioner and turn the nut to activate the position of the sliding card. Place the slide of the handle in the middle of the film and the desktop, make a groove in the positioning slot at the cutting position, adjust the position of the card near the edge of the desktop, tighten the nut and be in the state. positioning. Drill the protective film with the film cutting tool in the groove where it is positioned, move the locator and the film cutter to cut the excess film, and then wipe it with water.